PDA

View Full Version : install page error


ms_peacefull
09-30-2004, 07:51 AM
error: Can't write connexion template.

This is the error I get, right under the word Installation after I complete all fields, ie. username=*, password=*, dbname=*, host=localhost, table prefix=tbName (not sure if that is usable), port & sock left blank.

Basically the page just stays the same and the error gets written underneath the word Installation.

Any help is appreciated.

Thanks, Dave.

ms_peacefull
09-30-2004, 08:10 AM
Very well. I'm ok.

I back checked and found that in fact though I thought I went through the install instructions fully, I hadn't.

I didn't chmod the install dir nor did I chmod connect.php, both to 777.

Now it works. Thanks everyone.

vinyl-junkie
09-30-2004, 05:44 PM
Glad to see that you got phpdig up and running. :)

For anyone who might be reading this thread, it's worthy of saying again that there are Quick Installation Instructions in the phpgid documentation (http://www.phpdig.net/navigation.php?action=doc). Anytime you have trouble installing or setting up this software, you'd do well to read (or re-read) this page.

Hope it helps. :)